How To Stain Hardwood Floors

If youre using a waterbased stain. Top the finish with a protective and glossy coat of polyurethane sealer. Man opens a can of stain to do a test on the hardwood floor surface.

how to stain hardwood floors

How To Apply Polyurethane To Wood Floors Ask The Home Flooring Pros

How To Bleach Hard Wood Floors Hunker

Old Wood Floors Refinish Or Replace Brownstoner

Vacuum floor between each sanding and when finishedstep 3 clean floor with mineral spirits and a soft cotton cloth to pick up any remaining dust or dirt.

How to stain hardwood floors.

Before you begin you may want to hang a plastic drop cloth.
After 5 or 10 minutes.
How to stain a hardwood floor in 5 steps step 1 remove carpeting.
Test the stain in an inconspicuous area of the floor or on a sample piece of wood before applying it to the entire floor.

Staining floor test spot.
The amount of stain that a floor can absorb is finite.
Apply a second coat of polyurethane and allow to dry at least overnight.
How to stain and seal hardwood floors.

Apply stain to the hardwood floor in one 2 foot section at a time using a lambswool applicator.
How to stain a hardwood floor step 1.
Once the floor has dried apply the stain evenly.
The floor will not get darker if you flood it with an excess of stain or apply a second coat.

If you live in an older house that has carpeting over the hardwood floor.
Use a broom dustpan to sweep away.
Sand lightly and apply the second coat of polyurethane.
If sanding by hand use 3 different grits of sandpaper 30 60 and 80.

Remove dust with a heavy duty shop vac followed by rags dampened with mineral spirits.
Use a floor sanding machine and edge sander or sand by hand.
Step 1 repair obvious defects such as nail holes cracks or gouges in the floor using a wood putty or fillerstep 2 sand floor in direction of grain of the wood.
Use a tack cloth to wipe up all dust.

Youll need to rough up the smooth hard surface from the first coat of varnish so that the second coat will adhere well.
Sand the floor completely and vacuum thoroughly to remove all sawdust.
Sweep vacuum wash.
Using excess amounts or applying multiple coats of stain can cause the stain to bleed back where it wicks back up to the surface of the board as solvent begins to evaporate.

Here were using rags but some people prefer lambswool applicators.
Use a method called water popping in which you run a wet mop or cloth over.
Dip rag or sponge into stain and apply stain to floor.
Still other contractors apply stain by squirting the floor with stain out of a clean condiment bottle and spreading it with a white pad on the buffer.

Sand lightly with a fine sandpaper like 220.