How To Frame A Bathroom Mirror

Frame your mirror that has plastic clips. How to build a frame around a bathroom mirror. Also be generous with the amount of liquid nails you use.

how to frame a bathroom mirror

Framing A Bathroom Mirror Tempting Thyme

How To Frame A Bathroom Mirror The Creative Mom

How To Diy Upgrade Your Bathroom Mirror With A Stained Wood Frame

Add latex paint extender to paint lengthening drying time.

How to frame a bathroom mirror.

If you use mirror caulk press the frame into place and use painters tape to secure until the adhesive can cure.
To attach the frame to the mirror use mirror caulk or screws.
Heres one of the corners dont be afraid if they dont match up perfectly.
In this diy tutorial jon provides step by.

Measure the mirror and add 2 inches to the length and width.
This should leave a 1 in overhang when installed on the mirror using painters tape to hold the corners together assemble the frame without glue on a flat surface.
For example say your mirror is 64 long and you chose a 4 square block for the corners.
Using a miter saw cut each end at a 45 degree angle.

Let dry two hours.
Cut the top bottom and sides to those lengths on the outside edge with 45 degree miters on both ends.
Save yourself the hassle of trying to apply it without a gun or a 2nd trip to the store and make sure you pick one up.
How to frame a mirror step 1.

Get a caulking gun to apply your liquid nails.
Diy experts show how to make a wood frame for a bathroom mirror.
Nothing that a bit of caulk cant fix.
How to frame out that builder basic bathroom mirror for 20 or less apply your liquid nails or glue to the back of the board but make sure to leave an inch or so at the top of the board so you wont see the glue reflected in the mirror.

Put the liquid nails in the center of the molding.
The total length of each piece will be measured from tip to tip the long end of the miters.
You would subtract 4 inches times 2 to get the length of the board that will go between them.
Make the blade height the rip width and the width the height.

I used tape to hold it in place while it dried.
This will remove the remaining portion of the notch.
Measure mirror and select frame style.
Next reverse the saw settings.

Customized frames give a clean look thats more permanent than a decorative mirror.
If using screws fill screw holes with spackling compound then sand and paint with another coat for a beautiful finish.
Paint front sides and edges of trim.