How To Install Quarter Round

When nailing with a nail gun apply pressure to the 14 round at a 45 degree angle where the nail is going and push the 14 round down tight to the floor so the 14 round is tight to the floor when you pull the trigger. Hold the nail at a slight angle to the floor just above the bottom of the baseboard and tap lightly with a hammer until the head of the nail is just above the surface of the molding. Attach the quarter round molding to the base of the baseboard.

how to install quarter round

How To Install Quarter Round Molding With A Hammer And Nails

How To Install Quarter Round Around Bathtub The Home Design Software

Attach the quarter round trim to the base board and not to the actual laminate flooring.

How to install quarter round.

In step one weve cut two lengths of quarter round with two outside miters on each end away from the corner.
Step 2 molding for the doorway wall.
Floors are not always flat the good thing about 14 round is its flexible enough to follow the contour of the floor.
Make sure to cut this piece about 12 inches longer than it needs to be.

How to apply quarter round trim attaching quarter round.
Cut both pieces in opposite directions.
Quarter round is available in.
Cream colored pieces shown are quarter round.

Drive a finish nail into the baseboard.
Continue to 13 of 13 below.
If you are placing quarter round in front of the baseboard use any size you prefer or that will fill any gaps between the end of your new flooring and the wall.
Make 45 degree cuts on the ends of 2 different molding pieces.

The most common size is 34 inch.
Put the tapered end of the nail set on the head of the nail.
Unless youre installing a single piece of quarter round between two.
Do not glue the wall side or floor side of the return piece.

Press the return piece in place so the mitered edges meet and allow the pieces to sit undisturbed until the glue dries.
Cut quarter round pieces at a 45 degree angle to form joints.
How to install quarter round molding.
Cut another length of molding that fits between the doorway opening and a piece of quarter round molding that you just installed.

Use this type of cut to form corner joints wherever walls meet.
The laminate flooring is designed to be a free floating floor as it could expand contract so you dont.
Installing quarter round in corners.
This would match the top of the board perfectly.

Instead apply wood glue to the mitered edge of the return piece where it meets the first piece.
When adding a piece of quarter round to the top of a piece of 1 inch trim use 34 inch quarter round.
Because its finish trim install quarter round with finish nails.
The cuts on the other ends intersecting with the corner will appear the same unless you choose to use the coping method.

Installing the quarter round.
When you join the pieces together you will get a square 90 degree angle that leaves minimal gaps on the wall.